A single Moby housing contain a fluoride filter cartridge to be fitted into your cold water tap supply.
Note that there is no taste and chemical filtration with this unit. If you wish to remove fluoride and improve the taste and odour please see the Moby TF.
When fitting this mains water filter please allow for a minimum of H 38cm x W 30cm x D 18cm.
Your kit will include:
1 x big blue filter housing
1 x white housing bracket plus screws and washers
1 x Activated Alumina cartridge for fluoride reduction
Either 1/2 for 15mm or 3/4 for 22mm ports
2 x Isolating flexis (no need for extra ball valves)
1 x double check valve - either 15mm or 22mm
1 x housing spanner
Fitting instructions for your plumber
Cartridge details:
1 x 4.5 x 10" activated alumina fluoride removal filter cartridge
10 micron
Temperature range 40°F (4°C) to 100°F (38°C)
Pressure range 25 psi (1.7 bar) to 100 psi (6.9 bar)
Capacity 5,000 mg/l
Flow rate - 0.38 lpm / 0.25 gpm
Reduction ability - 10ppm to <0.2ppm
Do you have to install a mains water filter under the sink?
No, you don't. You can install your mains water filter wherever the cold water supply enters your house. This could be a utility room, garage, or other location.
* Watts components are sometimes replaced with other similar quality items due to supply chain issues. Brassware and other plumbing accessories are sourced from UK suppliers.
