Moby TM Replacement Water Filter Cartridges

This is our replacement cartridge set for our Moby TM, taste and metals mains water filter. 

1 x carbon block filter cartridge for chlorine, taste, odour and sediment reduction.

1 x 4.5" x 10" cannister containing 2 x GAC10N/KDF-BOM cartridges.

Cartridge details:

• Watts WCBFF975 coconut shell carbon block filter cartridge for chlorine, taste, odour and sediment reduction.
• 5 micron / 4.5 x 10"
• Outperforms GAC cartridges as it has superior chlorine reduction (up to 99%), lower pressure drop, will not channel and costs less than a GAC cartridge.
• Media wrap between centre tube and carbon block to reduce carbon fines.
• 100% coconut shell carbon.
• FDA grade components and materials.
• Recommended flow rate - 4 gpm
• Maximum operating pressure: 125 PSIG
• Operating temperature: 10°C - 52°C / 50°F - 125°F
• Chlorine reduction - >10,000 Gal @ 2 gpm
• Tested and certified under NSF / ANSI standard 42 for materials only.

or on some occasions a Pure CTO 4510-05 cartridge may be sent. This does the same job as the Watts WCBFF975. They're just different brands.

• Pure CTO 4510-05
• 4.5 x 10
• 5 micron
• 12,000 gallons @ 2.0gpm or 12 months; whichever comes first
• Certified NSF/ANSI standard 42 for materials only
• Certified by ISO 9001
• Performance tested and verified by independent laboratory testing

And...

• 2 x GAC10N/KDF-BOM cartridge which contains 0.75lbs of KDF and 0.75 litres of GAC
• 2.5 x 10"
• 20 micron
• 2,500 gallons/11,365 litres cartridge lifespan, or 12 months; whichever comes first

We send you a cartridge replacement reminder email every 6 months so that you can check your mains water filter performance. 

Why do I need to change the o-ring?

You can tell if the seals start leaking, which is obvious, I know.

Even if there are no leaks you may find that the profile of the O ring becomes flattened because of prolonged time under compression. The cross section should be round and if it's not it may not seal easily.

However, I recommend that you replace the O rings every two or three years as a precautionary measure.

One of the main reasons for changing O rings periodically is that as they age and compress, the housing bowl needs to be tightened excessively. That leads to difficulty loosening the bowl from the cap next time the cartridge needs to be replaced.