Fountain Filters logo

Home / UV Water Filters / Watts UV Water Filters / Replacement UV Lamp for Watts WUV6-230

Replacement UV Lamp for Watts WUV6-230

Replacement UV Lamp for Watts WUV6-230

£53.99
Replacement UV Lamp for Watts WUV6-230 6 gpm UV water filter.


SKU: GPH436T5L-4

Product Description

This is the replacement UV water filter lamp (Philips GPH436T5L/4 for Watts PWUVBULB6) for the Watts UV disinfection system WUV6-230.

Lamps are easy to replace and are rated for a 12 months (9,000 hours*) continuous service life. You must change your lamp every 12 months as risk of the lamp not working effectively after this time is HIGH and your water may not be safe. You must also have a pre-filter installed with a minimum of 5 micron filtration and the reason for this is that any sediment in your water will coat the inside of the UV systems quartz sleeve making the UV ineffective and your water unsafe.

You can purchase this with a quartz sleeve. Please see product options. Alternatively, if it's just a sleeve that you're after you can purchase these separately.

24 Litres per minute UV filter.

Power output - 21 watts

Length - 436mm

Base - 4 pins single ended

Also known as GPH436T5L/4 HA, GPH436T5L/4 LT, GPH436T5L/LS/21W

Uses

  • Well water
  • Homes
  • Water Systems
  • Aquaculture
  • Food Service
  • Water coolers
  • Reverse Osmosis (RO) systems

Replacing your UV lamp and servicing your UV system

Handle the quartz sleeve and lamp by the ends only. Avoid touching the sides.

  1. Disconnect power.
  2. Turn your water off and open valve downstream of system to relieve pressure.
  3. Remove the vinyl cap and unscrew the nut.
  4. Pull out lamp about 2" from the chamber.
  5. While holding lamp carefully remove lamp socket on exposed end.
  6. Pull lamp from chamber.
  7. Remove O ring from the end of the quartz sleeve.
  8. Remove quartz sleeve.
  9. To fit a new quartz sleeve/lamp follow steps 8 to 1 in reverse.

Maintenance

To get the best out of your UV system we recommend the following:

  • The quartz sleeve should be cleaned with glass cleaner every 12 months. Replace after 24 months.
  • Replace your lamp every 8,000-9,000 hours of operation (approximately 12 months of continuous service).

UV lamps and quartz sleeves are delicate and therefore easily damaged. So, be really careful when you're removing and replacing them.

Please note that to reduce handling these lamps will be sent to you directly from our supplier. 

* Lamps have no warranty due to possible damage caused by power interruptions.

Related Products

 

Need Assistance?

We're here to help! Our dedicated helpline is ready to answer your questions and provide solutions.

© 2011-2025. shopping cart system by 1Ecommerce : online payments system by 1Epay