This is the replacement quartz sleeve (PWUVQS12) for the Watts UV disinfection system WUV12-230.
Quartz sleeves are easy to replace and you should do this every two years.
You must have a pre-filter installed with a minimum of 5 micron filtration and the reason for this is that any sediment in your water will coat the inside of the UV systems quartz sleeve making the UV ineffective and your water unsafe.
You can purchase this on it's own or with a lamp. Please see PWUVBULB12 if you'd like a quartz sleve/lamp combo.
45 Litres per minute UV System.
Uses
Well water
Homes
Water Systems
Aquaculture
Food Service
Water coolers
Reverse Osmosis (RO) systems
Replacing your UV lamp and servicing your UV system
Handle the quartz sleeve and lamp by the ends only. Avoid touching the sides.
Disconnect power.
Turn your water off and open valve downstream of system to relieve pressure.
Remove the vinyl cap and unscrew the nut.
Pull out lamp about 2" from the chamber.
While holding lamp carefully remove lamp socket on exposed end.
Pull lamp from chamber.
Remove O ring from the end of the quartz sleeve.
Remove quartz sleeve.
To fit a new quartz sleeve/lamp follow steps 8 to 1 in reverse.
Maintenance
To get the best out of your UV system we recommend the following:
The quartz sleeve should be cleaned with glass cleaner every 6-12 months. Replace after 24 months.
Replace your lamp every 8,000-9,000 hours of operation (approximately 12 months of continuous service).
UV lamps and quartz sleeves are delicate and therefore easily damaged. So, be really careful when you're removing and replacing them.
